Winter Special Sale - Limited Time 60% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 575363r9

Welcome To DumpsPedia
  1. Home
  2. Fortinet
  3. NSE 7 Network Security Architect
  4. NSE7_SDW-7.0
  5. Fortinet NSE 7 - SD-WAN 7.0 Questions and Answers

NSE7_SDW-7.0 Sample Questions Answers

Questions 4

What are two common use cases for remote internet access (RIA)? (Choose two.)

Options:

A.

Provide direct internet access on spokes

B.

Provide internet access through the hub

C.

Centralize security inspection on the hub

D.

Provide thorough inspection on spokes

Buy Now
Questions 5

Which two statements are true about using SD-WAN to steer local-out traffic? (Choose two.)

Options:

A.

FortiGate does not consider the source address of the packet when matching an SD-WAN rule for local-out traffic.

B.

By default, local-out traffic does not use SD-WAN.

C.

By default, FortiGate does not check if the selected member has a valid route to the destination.

D.

You must configure each local-out feature individually, to use SD-WAN.

Buy Now
Questions 6

Which diagnostic command can you use to show the configured SD-WAN zones and their assigned members?

Options:

A.

diagnose sys sdwan zone

B.

diagnose sys sdwan service

C.

diagnose sys sdwan member

D.

diagnose sys sdwan interface

Buy Now
Questions 7

Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)

Options:

A.

The traffic shaper drops packets if the bandwidth is less than 2500 KBps.

B.

The measured bandwidth is less than 100 KBps.

C.

The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.

D.

The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.

Buy Now
Questions 8

Which two tasks are part of using central VPN management? (Choose two.)

Options:

A.

You can configure full mesh, star, and dial-up VPN topologies.

B.

You must enable VPN zones for SD-WAN deployments.

C.

FortiManager installs VPN settings on both managed and external gateways.

D.

You configure VPN communities to define common IPsec settings shared by all VPN gateways.

Buy Now
Questions 9

Refer to the exhibit.

Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)

Options:

A.

The number of simultaneous connections among all source IP addresses cannot exceed five connections.

B.

The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

C.

The number of simultaneous connections allowed for each source IP address cannot exceed five connections.

D.

The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.

Buy Now
Questions 10

Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.

What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?

Options:

A.

You must set ike-version to 1.

B.

You must enable net-device.

C.

You must enable auto-discovery-sender.

D.

You must disable idle-timeout.

Buy Now
Questions 11

Which statement is correct about SD-WAN and ADVPN?

Options:

A.

Routes for ADVPN shortcuts must be manually configured.

B.

SD-WAN can steer traffic to ADVPN shortcuts, established over IPsec overlays, configured as SD-WAN members.

C.

SD-WAN does not monitor the health and performance of ADVPN shortcuts.

D.

You must use IKEv2 on IPsec tunnels.

Buy Now
Questions 12

Refer to the exhibit.

Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change? (Choose two.)

Options:

A.

FortiGate flushes all sessions.

B.

FortiGate terminates the old sessions.

C.

FortiGate does not change existing sessions.

D.

FortiGate evaluates new sessions.

Buy Now
Questions 13

Refer to the exhibits.

Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true? (Choose two.)

Options:

A.

FortiGate does not install IPsec static routes for remote protected networks in the routing table.

B.

The phase 1 configuration supports the network-overlay setting.

C.

FortiGate facilitated the negotiation of the T_INET_1_0_0 ADVPN shortcut over T_INET_1_0.

D.

Dead peer detection is disabled.

Buy Now
Questions 14

Refer to the exhibit.

Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?

Options:

A.

type must be set to static.

B.

mode-cfg must be enabled.

C.

exchange-interface-ip must be enabled.

D.

add-route must be disabled.

Buy Now
Questions 15

Refer to the exhibits.

Exhibit A

Exhibit B

Exhibit A shows the source NAT (SNAT) global setting and exhibit B shows the routing table on FortiGate.

Based on the exhibits, which two actions does FortiGate perform on existing sessions established over port2, if the administrator increases the static route priority on port2 to 20? (Choose two.)

Options:

A.

FortiGate flags the sessions as dirty.

B.

FortiGate continues routing the sessions with no SNAT, over port2.

C.

FortiGate performs a route lookup for the original traffic only.

D.

FortiGate updates the gateway information of the sessions with SNAT so that they use port1 instead of port2.

Buy Now
Questions 16

Which are three key routing principles in SD-WAN? (Choose three.)

Options:

A.

FortiGate performs route lookups for new sessions only.

B.

Regular policy routes have precedence over SD-WAN rules.

C.

SD-WAN rules have precedence over ISDB routes.

D.

By default, SD-WAN members are skipped if they do not have a valid route to the destination.

E.

By default, SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member.

Buy Now
Questions 17

Refer to the exhibit.

Which statement about the role of the ADVPN device in handling traffic is true?

Options:

A.

This is a spoke that has received a query from a remote hub and has forwarded the response to its hub.

B.

Two hubs, 10.0.1.101 and 10.0.2.101, are receiving and forwarding queries between each other.

C.

This is a hub that has received a query from a spoke and has forwarded it to another spoke.

D.

Two spokes, 192.2.0.1 and 10.0.2.101, forward their queries to their hubs.

Buy Now
Questions 18

What does enabling the exchange-interface-ip setting enable FortiGate devices to exchange?

Options:

A.

The gateway address of their IPsec interfaces

B.

The tunnel ID of their IPsec interfaces

C.

The IP address of their IPsec interfaces

D.

The name of their IPsec interfaces

Buy Now
Questions 19

What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

Options:

A.

The FortiGate cloud key has not been added to the FortiGate cloud portal.

B.

FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

C.

The zero-touch provisioning process has completed internally, behind FortiGate.

D.

FortiGate has obtained a configuration from the platform template in FortiGate cloud.

E.

A factory reset performed on FortiGate.

Buy Now
Questions 20

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.

Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)

Options:

A.

London generates an IKE information message that contains the Toronto public IP address.

B.

Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.

C.

Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.

D.

The first packets from Toronto to London are routed through Hub 1 then to Hub 2.

Buy Now
Questions 21

Refer to the exhibit.

Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?

Options:

A.

All traffic from a source IP to a destination IP is sent to the same interface.

B.

All traffic from a source IP is sent to the same interface.

C.

All traffic from a source IP is sent to the most used interface.

D.

All traffic from a source IP to a destination IP is sent to the least used interface.

Buy Now
Exam Code: NSE7_SDW-7.0
Exam Name: Fortinet NSE 7 - SD-WAN 7.0
Last Update: Dec 3, 2024
Questions: 70
$66  $164.99
$50  $124.99
$42  $104.99
buy now NSE7_SDW-7.0