If the UPS5000-E is overloaded in normal mode, it transfers to bypass mode immediately. The bypass supplies power to loads to protect the UPS.
Due to simple operations and easy interconnection, which of the following communication types is recommended for NetEco northbound integration?
On the ECC800-Pro WebUI, which of the following is the first-level menu of the NMS Application?
In the FusionModule2000, if a device port complies with the Modbus RTU protocol, which device is used to connect to smart ETH gateway?
Three UPS5000-E-400Ks from a 2+1 parallel system. Which of the following statements about the parallel system are true?
Which of the following is a standard component in the FusionModule800 typical configuration?
Which of the following methods can be used to open the access control for the FusionModule2000 smart module?
The power system of a UPS2000-G-15K at a site is three-phase input and single-phase output. After installation, it is found that the mains and bypass inputs are three-phase, the output is single-phase, and the mains and bypass inputs share a power source. Which of the following statements are true about the UPS wiring mode?
The UPS can generate large leakage currents. A circuit breaker equipped with a residual current device (RCD) is not recommended. If leakage protection is required, consider the leakage current of the UPS and downstream devices.
If the battery charge current limit coefficient of the UPS5000-E is set to 0.1C10, which of the following statements about this parameter is true?