Winter Special Sale - Limited Time 60% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 575363r9

Welcome To DumpsPedia

H35-560 Sample Questions Answers

Questions 4

TD-LTE UE is set to trigger intra-frequency handover by A3 event. In order to reduce the trigger of A3 event, which of the following parameters can be increased? (multiple choice)

Options:

A.

eventA30ffset

B.

celllnd ivid ua IOffset_s

C.

celllnd ividualOffset_n

D.

hysteresis

Buy Now
Questions 5

In the case of FTP download or upload (or packet filling) without manual intervention, the throughput rate should be maintained at this time. If there is a sudden drop, call drops may occur.

Options:

A.

True

B.

False

Buy Now
Questions 6

Before the cluster optimization test, the target area must be divided into clusters. Which of the following statements are correct? (Multiple choice)

Options:

A.

The cluster division should span different areas of the test (planning) full coverage business

B.

Make full use of the terrain (mountains and rivers)

C.

Refer to the existing cluster division for network engineering maintenance

D.

When dividing the cluster, the drive test in each cluster can be completed in one day, usually about 6 hours for one drive test

Buy Now
Questions 7

What are the principles that need to be followed when planning LTE neighboring cells? (Multiple choice)

Options:

A.

Neighborhoods that are directly adjacent to the geographic location are generally regarded as neighboring cells

B.

For dense urban areas and ordinary urban areas, due to the relatively close distance between stations (0.3-1.0 km), neighbouring areas should do more

C.

Because there are no sequential I and possible questions in LTE neighboring cells, and the detection period is very short, it is only necessary to consider not missing neighboring cells, and it is not necessary to sort neighboring cells strictly according to signal strength.

D.

Turn on ANR to completely replace the neighborhood planning of the initial network

Buy Now
Questions 8

LTE can obtain various interface signaling through LMT, M2000, and drive test tools.

Options:

A.

True

B.

False

Buy Now
Questions 9

In the downlink scheduling, which factors will affect the allocation of downlink shared resources and the selection of MCS? (Multiple Choice)

Options:

A.

UE capability level

B.

The wireless environment where the user is located

C.

Cache status

D.

PHR (power headroom report) of UE

Buy Now
Questions 10

The reason values ​​for LTE RRC establishment include: emergency calk h ig h Priority Access x mt-Access mo-Singnalling and mo-Data.

Options:

A.

True

B.

False

Buy Now
Questions 11

RSRP reference signal received power refers to the average signal power received by all REs of a Symbo bearer Reference Signa within the measured frequency bandwidth.

Options:

A.

True

B.

False

Buy Now
Questions 12

Which of the following information can be directly observed through the Probe drive test tool? (multiple choice)

Options:

A.

PUSCH, PUCCH, RACH and SRS physical channel transmit power.

B.

TM mode

C.

Number of occupied carriers

D.

UE real-time transmit power

Buy Now
Questions 13

The intermodulation interference of the system is usually mainly caused by second-order and third-order intermodulation, and the frequency of the second-order intermodulation product is F=2f1±f2 or 2f2±f1.

Options:

A.

True

B.

False

Buy Now
Questions 14

LTE power control does not affect the coverage and capacity of the system.

Options:

A.

True

B.

False

Buy Now
Questions 15

Regarding TA planning, which of the following statements is incorrect?

Options:

A.

LTE of TAPlanning should be consistent with 2G/3G of LAPlan to be consistent

B.

Currently LTE of TALCan contain at most 16PieceTA

C.

LTE of TANumber of cells in Should be better than the corresponding2G/3G LASmall number of medium cells

D.

Each A single-operator cell can belong to multipleTA

Buy Now
Questions 16

During the X2 handover in the LTE system, if re-establishment occurs, which cells may be re-established? (Multiple choice)

Options:

A.

Source area

B.

ItemTarget area

C.

Third-party community

D.

Other cells in the source base station

Buy Now
Questions 17

Regarding the over-zone, overlapping coverage control, which of the following statements is wrong?

Options:

A.

Station height control: strictly control the station height to avoid over-zone interference

B.

Station spacing control: strictly avoid overlapping coverage sites within 100m

C.

Topological structure planning: the site distribution is as uniform as possible

D.

The angle of the sector in the station should be kept as close as possible to 60 degrees, direct sparring between stations can enhance coverage

Buy Now
Questions 18

High-end commercial buildings, airports, large venues, large shopping malls, high-end residential communities and other large traffic and VIP scenarios are suitable for co-deployment of MIMO solutions. What are the advantages of this solution? (Multiple choice)

Options:

A.

High capacity

B.

Can fully reflect the MIMO uplink and downlink capacity gain

C.

low cost

D.

project Low difficulty

Buy Now
Questions 19

In the LTE system, the mobility KPI is used to evaluate the mobility performance of the E-LTTRAN network. It directly reflects the quality of the user experience. Which of the following is not a mobility KPI?

Options:

A.

The success rate of switching out (same frequency/different frequency)

B.

Call establishment success rate

C.

Switch in success rate

D.

Success rate of switching out different systems

Buy Now
Questions 20

The insertion loss of the cavity power divider is larger than that of the microstrip power divider.

Options:

A.

True

B.

False

Buy Now
Questions 21

Which of the following adjustment measures has the highest priority?

Options:

A.

Antenna height

B.

Antenna direction angle antenna downtilt angle

C.

Antenna type

Buy Now
Questions 22

The uplink interference problem is judged by checking the RSRP of each cell.

Options:

A.

True

B.

False

Buy Now
Questions 23

Which of the following descriptions are correct for cross-zone coverage? (Multiple choice)

Options:

A.

Over-area coverage may form "islands", leading to dropped calls

B.

Cross-area coverage may cause UE transmit power limitation, causing access failure

C.

Cross-area coverage may result in unbalanced load between the cross-covered base station and surrounding base stations, resulting in low resource utilization of surrounding base stations

D.

For LTE, cross-area coverage will not cause interference to its neighboring cells

Buy Now
Questions 24

For the E-band of the LTE network, which system has the greatest impact on interference?

Options:

A.

GSM 900M

B.

GSM 1800M

C.

TD-SCDMA

D.

WLAN

Buy Now
Questions 25

Which of the following is the correct description of the following LTE neighboring cell planning? (Multiple choice)

Options:

A.

Geographically directly relatedNeighboring cells are generally used as neighboring cells

B.

For dense urban areas and ordinary urban areas, the distance between stations is relatively close (0.3-1.0kilometer),Neighborhood should do more

C.

becauseforLTEofThe neighboring area does not exist in orderI,CanProblem, and the detection cycle is very short, so you only need to consider not missing neighbors, not wantSort neighboring cells strictly according to signal strength

D.

ANRThe function can completely replace the initial networkNeighbourhood planning

Buy Now
Exam Code: H35-560
Exam Name: HCIA-LTE-RNP&RNO V1.0
Last Update: Nov 30, 2024
Questions: 84
$66  $164.99
$50  $124.99
$42  $104.99
buy now H35-560